JUSTNAILS Premium Fullcover Tip Shellac Starter Set - for extremely fast and beautiful nails

With this high-quality set, you get in one click all the gels and accessories you need for your world-renowned Fullcover Tips nail modeling. Perfect for a quick application at home. Without filing the shape and without much experience, you can easily create beautiful nails that will last you up to 4 weeks.

SET APPLICATION:

• First, select the appropriate sizes of tips and lay them out ready. Use the buffer and the half-moon file to thoroughly roughen the inside of the tips. Tips cannot hold on the nail if they are not roughened!
• Prepare your nails and carry out a manicure:
• Wash your hands and ideally disinfect them.
• File your nails into shape using the finer side of the half-moon file.
• Gently push back your cuticles with a rosewood stick or a pro-pusher and also lift them slightly to make it easier to remove cuticles with the cutter or nail cuticle scissors.
• If necessary, cut away dry and white cuticles carefully without injuring yourself. Start slowly and work step by step.
• Now use a buffer to mattify the nail plate and carefully go into corners and edges to remove invisible cuticles. Depending on genetics, there may be a lot or a little invisible cuticle on the nail plate. This must be completely removed so that gel can adhere. You can also use your half-moon file to get better into the edges and corners. If your nails are untreated and this is your first time doing your nails, feel free to also file with the fine side of the half-moon file WITHOUT pressure on your nail plate. This step is not recommended with a damaged nail plate. Professionals use a drill with suitable cuticle bits for natural nail preparation as it allows 100% perfect access to all edges, and due to the fine rotating movement of the diamond bits, the nail plate is not damaged as much as with a buffer but is much better prepared because it is evenly and sufficiently mattified.
• Remove nail dust from your nails and apply Ultra Prep over the entire nail plate. Let it dry for a few seconds and proceed with Ultra Double Bond. Apply this over the whole nail plate and let it dry in air for about 20 seconds. This leaves a sticky layer, do not touch!
• Now apply a very thin layer of Base Gel Super Bond to the natural nail and cure it under a UV/LED lamp for 60 seconds.
• Take the Gummy Gel with a spatula, propusher, rosewood stick or clean hands (gloves are a must for client application) and roll it into a ball.
  Press this into the suitable tip and push the gel halfway into the tip. Press the tip onto the nail and move it slightly back and forth so that the Gummy Gel has no bubbles and distributes well. Be careful to apply as little pressure as possible so that gel is not pushed out at the side edges. Once the tip is perfectly positioned, cure it in the lamp.
• After complete curing in the lamp (about 60 seconds), you can roughen the tip with the buffer or file and file away any gel residues that may have been pushed out. TIP: a drill allows you to very nicely blend the transition at the cuticle.
• When the tip is fully roughened, you can optionally apply a colour gel and cure (60 seconds). If the coverage is not sufficient, apply another layer after curing in the lamp and cure again. Always apply the colour gel thinly towards the tip so the nails do not look too thick later.
• Now you can seal the nails with the Master Top and cure again for 120 seconds.
• Wait until the nails have cooled and then apply nail oil to the cuticles.

How to remove nails after wear time:

You have two removal options:

1. Remove with acetone: Here you must roughen the top layer well with a file so that the remover liquid can penetrate well. Wrap your fingers with aluminium foil containing a wipe or kitchen paper soaked with remover liquid around the nail to be removed. Let this act airtight for about 10-15 minutes and then scrape off the softened gel including the tips again with a rosewood stick or propusher. This option, however, requires constant re-manicuring with re-roughening of the natural nail completely and is NOT recommended for long-term use.

2. Remove nails with a file or drill: Here you must file down the gel and tips until only a very thin residual layer remains on the nail, which does not interfere with a new modeling. Thus, you only need to prepare and file the newly grown nail again. The remaining natural nail is still protected by the previous gel and is not injured by another filing. This keeps your natural nails healthy even after years of artificial nails. Be extremely careful not to hurt yourself or damage the nail plate. This option requires a lot of sensitivity and care. This option is of course much faster with a drill.

Keep all items out of reach of children and fire. Avoid contact with eyes. In case of contact with eyes, rinse with cold water. Consult a doctor.